Agent Installation - Knowledge base

Unable to Add Domains in the Scope of Management (SoM)

Problem

You are trying to add domains in the SoM of Endpoint Central MSP. You have selected the network type as Active Directory and specified all the required information. However you are unable to add the domains. The error message that you see on the screen is, 'Validation Failed'. You cannot install the agent in the SoM.

You can face this problem only when you have selected Active Directory as the network type. You will not face this problem in a workgroup-related setup.

Cause

The reasons for this error could be one of the following:

  • Incorrect name of the domain, Active Directory domain or domain controller specified
  • Incorrect administrator credentials (username and password) specified
  • Invalid user. User does not have admin privileges in the specified domain or Organizational Unit (OU)
  • Inaccessible domain controller

Resolution

You are required to identify the cause for this problem and follow the relevant solution from the list given below:

Incorrect name of the domain

Correct spelling errors, if any, in the domain name, domain contoller name and the AD domain name that you have specified

Incorrect administrator credentials

Ensure that the credentials that you have specified have administrative rights in all client systems

Invalid user

  • Ensure that the domain user name you have specified has administrator privileges for the specified OU and domain
  • Check the password, which you have specified, for errors related to case and spelling. If there are no spelling errors, make the appropriate the changes in the Add Domain dialog box in the SoM.

Inaccessible domain controller

Note: If you have migrated your domain controller, ensure that you have updated the domain settings under SOM.

  • Ensure that the specified domain controller is accessible (you could have specified either the domain controller's machine name or IP address). The reasons why the domain controller could be inaccessible are as follows:
    • Network failure (contact your IT administrator)
    • Computer in which the domain controller has been set could be switched off
    • Active Directory is not running in the domain controller
  • Check if the Active-Directory domain that you have specified is correct. To check this information, follow the steps given below:
    1. Click start>Run
    2. Enter cmd
    3. Enter set u
    4. Click Enter

    You will see the following information:

    • USERDNSDOMAIN= Domain name of the Active Directory
    • USERDOMAIN= Domain name
    • USERNAME= User name
    • USERPROFILE= Profile of the user
  • Check if the domain controller name that you have specified is correct. To check this information, follow the steps given below:
    1. Click start>Run
    2. Enter cmd
    3. Enter SET LOGONSERVER
    4. Press Enter

    Note: Ensure that you check for the right domain-controller name in the computer that belongs to that domain.

    You will see the term LOGONSERVER on the screen. This is the name of the domain controller.

Applies to: Endpoint Central MSP Installation, Agent Installation failure, Add Domains in SoM

Keywords: Install Agents, Endpoint Central MSP Agent Installation, Agent Installation, Add Domains in Scope of Management

Remote Desktop & Mobile Device Management Software for MSPs trusted by